New kitchen cabinet pulls are too loose how can I tighten them up?

June 27th, 2009 | by admin |
Jasmyn asked:


I bought new pulls for my old kitchen cabinet doors. The machine screws don’t screw in all the way into the new pulls, because the cabinet doors are not thick enough.

Can I put washers behind the pulls and again behind the back of the cabinet door to tighten up the loose pulls and make up for the thin cabinet door? I need to make up about 1/8 of an inch difference.

Thanks from a damsel in distress.

Collectable Kitchen Plates

Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.
  • Digg
  • Bumpzee
  • del.icio.us
  • Facebook
  • Furl
  • Mixx
  • NewsVine
  • Reddit
  • StumbleUpon
  • YahooMyWeb
  • Google

  • New kitchen cabinet pulls are too loose how can I tighten them up?
  • The hinges in our kitchen cabinet door became loose (the screws are loose and don’t attach properly). I put
  • Does anyone have any creative ideas for kitchen cabinet door pulls or knobs. I don’t want to use standard?
  • Need help with replacing cabinet pulls in kitchen?
  • Need help with replacing cabinet pulls in kitchen?
  • Any way to add cabinet door knobs to cabinets with no holes drilled without going to that expense?
  • How to repair a loose kitchen cabinet?

    1. No Responses to “New kitchen cabinet pulls are too loose how can I tighten them up?”

    2. By cdpaso on Jun 27, 2009 | Reply

      I think yoy answered your own question….Good job

    3. By WDOUI on Jun 28, 2009 | Reply

      The hardware store to buy washers why dont you can use washers why dont you go to the hardware store to the hardware store to the hardware store to the hardware store to buy washers if you can use washers if you.

    4. By Mark C on Jun 29, 2009 | Reply

      Just buy shorter screws, they are 8/32 thread and come in different lenths.

    5. By doc on Jul 1, 2009 | Reply

      You have two options 1use washers as you think or2 cut about 5mm off the bolts

    Sorry, comments for this entry are closed at this time.